Shenzhen Relight Technology Co., Ltd./Shenzhen Relight Lighting Co., Ltd.
Add to Cart
Technologies: ON/OFF
Application:
This product is suitable for engineering projects, outdoor lighting buildings, hotels, shopping malls, and other decorative lighting purposes.
Product Specifications
| P/N | LED Quantity | CCT(K) | CRI | LEDs/m | LUMENS (lm/m) | Vf. (V.) | Current (mA/M) | Power (W/M) | Cut Length (MM) | Max Run (M) |
| RL-FV2416024283520-830-FWD2721 | 2835 | 2700 | 80/90 | 24 | 1500 | 24 | 833 | 20 | 41.67 | 5 |
| 3000 | 1600 | |||||||||
| 4000 | 1700 | |||||||||
| 6500 | 1700 |
Other Specifications
| Protection grade | IP67 |
| Working temperature(°C) | -25~+60 |
| Storage environment temperature (°C) | -25~+70 |
| Standard length | 5 |
| Maximum cascade length(m) | 5 |
| weight | / |
Remark
The test environment temperature is 25±2°C;
The above data are typical values, the actual parameters of the product may be different from the typical data; the data is subject to change without notice;
The above "/" means that this parameter is not required for the time being.
Applied Standards
CE ROHS cULus LISTED ETL Intertek CB Reach UKCA
Common product faults and their troubleshooting methods
| Fault Phenomena | Possible Causes | Troubleshooting Methods |
| All lights off | 1. Mains power failure | Power on |
| 2. Open circuit or short circuit at switching power supplyoutput triggering auto-protection | Troubleshoot and restore power | |
| 3. Reverse polarity at LED strip power input | Check wire connection status to ensure correct polarity | |
| Partial lights off | 1. Partial switching power supply failure | Inspect power supply system and resolve faults |
| 2. Wiring error in partial LED strip circuits | ||
| 3. Reverse polarity in partial LED strips | Correct wiring | |
| LED uneven brightnessor insufficient brightness | 1. Power supply overload | Replace with higher-power supply according to load |
| 2. Excessive line loss in switching power circuits orsignificant line loss discrepancies | Maintain LED strip operating voltage within +5% of rated voltage 1. Shorten power cable length between power supply and LEDstrip or use larger gauge wires; 2. Ensure number of LED strips per circuit ≤ max allowed cascadingquantity and keep cascading quantities similar per circuit). | |
| 3. Excessive serial connection of LED strips | Adjust LED strip quantity per power branch to meet maxallowed cascading requirements per circuit | |
| LED flickering | 1. Poor contact at connection points | Identify and resolve poor contact points |
| 2. Switching power supply malfunction | Replace switching power supply |
- If the external flexible cable of this product is damaged, the cable must be replaced by the manufacturer or similarly qualified personnel to prevent hazards.
- For specific installation arrangements and precautions, refer to the product user manual.
- Data in this specification is based on standard products, Actual delivered products may vary, subject to physical measurements.
- All product diagrams in this specifcation are schematic diagrams, Actual delivered products may differ, subject to physical obiects
- Technical modifications may be implemented without prior notice.
- Shenzhen Meishang Lighting Co., Ltd. reserves the final interpretation rights of this manual.